The reason I didn’t just switch over to DVI-D after I discovered this issue was mainly because of my desire to find out what went wrong. With that laptop we are able to extend the. This is what drove me to initially use DisplayPort. Actually what happens, when we connect the laptop to a docking station, it should duplicate the screen automatically to the docking station screens and its the issue with only one laptop, it says 'No DP signal from your Device' message but in the windows display settings it shows that its duplicated. I have a personal dislike of DVI cables and the way you have to screw them in. PC Data Center Mobile: Lenovo Mobile: Motorola Smart Service Parts. I wanted to make full use of the 144Hz functionality on the monitors, and to do so I would have to use either DisplayPort or DVI-D. docking station is a device that allows your laptop to be connected to external devices. On the left monitor I could see “DisplayPort- No Signal”, and on the right was my usual desktop. I made sure all the cables were tight, unplugged them and replugged them- sure enough I even turned it off and on again- but to no avail. You could run a USB-C cable from your system to Display 1 and then a DisplayPort cable from Display 1 to Display 2. my PC no external monitors connect via the docking. If you dont have a USB-C port on your device, the ASUS has an adapter that. my laptop direct it works so isolated the problem to the docking station. If DisplayPort is not selectable, please make sure the DisplayPort cable has been properly connected to both devices. Docking Station Lenovo 40a1 Port Replicator Without Psu. 2) Check the input menu on the screen to see if the DisplayPort option is selectable. This all works fine using my personal Windows laptop, but the monitor doesn't wake up when connected to the MacBook. I then plug the dock into my MacBook Pro 2018 (work laptop) using the usb-c cable. They plug directly into an Nvidia GTX 1080. Since your displays have both USB-C inputs and DisplayPort outputs to support daisy-chaining, you might actually be able to cut out your docking station entirely. If you can’t update to the latest driver when connected via DisplayPort due to no signal, switch connections to HDMI if possible. My setup is like this: I have a Dell U2719D Monitor plugged into my D6000 docking station using a DP cable. My PC set-up consists of two 144Hz monitors connected via DisplayPort cables. A bit of background - why use DisplayPort anyway? It was fine the day before, and it hadn’t been touched that day, so what gives? Let me back up a little… (unless you’re too eager and just want to see the solution). I recently faced a hardware issue on my PC at home whereby one of my two monitors seemed to suddenly no longer connect when I booted. DisplayPort no signal: The question “ have you tried turning it off and on again?” gets joked about a lot in computing when someone has a problem, it’s well known that a quick reboot often works a treat.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |